[ 0 / 4 ] Application profile is too short (7.11 s)

If the overall application profiling time is less than 10 seconds, many of the measurements at function or loop level will very likely be under the measurement quality threshold (0,1 seconds).
Rerun to increase runtime duration: for example use a larger dataset or include a repetition loop.

[ 2.99 / 3 ] Most of time spent in analyzed modules comes from functions compiled with -g and -fno-omit-frame-pointer

-g option gives access to debugging informations, such are source locations. -fno-omit-frame-pointer improve the accuracy of callchains found during the application profiling.

[ 3 / 3 ] Optimization level option is correctly used

[ 3 / 3 ] Host configuration allows retrieval of all necessary metrics.

[ 2.99 / 3 ] Architecture specific option -march=znver5 is used

[ 2 / 2 ] Application is correctly profiled ("Others" category represents 0.17 % of the execution time)

To have a representative profiling, it is advised that the category "Others" represents less than 20% of the execution time in order to analyze as much as possible of the user code

[ 1 / 1 ] Lstopo present. The Topology lstopo report will be generated.

[ 4 / 4 ] Enough time of the experiment time spent in analyzed loops (73.26%)

If the time spent in analyzed loops is less than 30%, standard loop optimizations will have a limited impact on application performances.

[ 2 / 4 ] A significant amount of threads are idle (43.72%)

On average, more than 10% of observed threads are idle. Such threads are probably IO/sync waiting. Some hints: use faster filesystems to read/write data, improve parallel load balancing and/or scheduling.

[ 2 / 4 ] CPU activity is below 90% (58.47%)

CPU cores are idle more than 10% of time. Threads supposed to run on these cores are probably IO/sync waiting. Some hints: use faster filesystems to read/write data, improve parallel load balancing and/or scheduling.

[ 4 / 4 ] Loop profile is not flat

At least one loop coverage is greater than 4% (54.06%), representing an hotspot for the application

[ 4 / 4 ] Enough time of the experiment time spent in analyzed innermost loops (62.23%)

If the time spent in analyzed innermost loops is less than 15%, standard innermost loop optimizations such as vectorisation will have a limited impact on application performances.

[ 4 / 4 ] Affinity is good (97.81%)

Threads are not migrating to CPU cores: probably successfully pinned

[ 3 / 3 ] Less than 10% (0.00%) is spend in BLAS1 operations

It could be more efficient to inline by hand BLAS1 operations

[ 0 / 3 ] Too many functions do not use all threads

Functions running on a reduced number of threads (typically sequential code) cover at least 10% of application walltime (46.59%). Check both "Max Inclusive Time Over Threads" and "Nb Threads" in Functions or Loops tabs and consider parallelizing sequential regions or improving parallelization of regions running on a reduced number of threads

[ 3 / 3 ] Cumulative Outermost/In between loops coverage (11.04%) lower than cumulative innermost loop coverage (62.23%)

Having cumulative Outermost/In between loops coverage greater than cumulative innermost loop coverage will make loop optimization more complex

[ 2 / 2 ] Less than 10% (0.00%) is spend in BLAS2 operations

BLAS2 calls usually could make a poor cache usage and could benefit from inlining.

[ 2 / 2 ] Less than 10% (0.02%) is spend in Libm/SVML (special functions)